Sanyo VPC-AZ3 EX - Manual (Page 63)

CAPTURING STILL IMAGES
1
Set the camera to the still image
shooting mode (see page 59).
2
Take a picture.
1
Point the camera lens at the
subject. Slowly press and hold the
shutter release button halfway.
œ
The area in the center of the LCD
monitor comes clearly into focus,
and the focus icon
ë appears in
the upper left corner (focus-lock).
œ
If the Shooting Setting Screen
(see page 45) or Shooting
Information Screen (see page
124) was displayed, it is exited.
œ
The focus icon does not appear if
the focus is set to telephoto
å
or manual
!
, or during quick
shot shooting (see page 121).
2
Press the shutter release button all
the way.
œ
The image is captured.
NOTE
œ You can view the image captured on the LCD monitor by holding the
shutter release button down.
œ The stand-by indicator will flash red while the image is being written to the
memory. Another image can only be captured when the stand-by indicator
lights green again.
œ The camera is ready for capturing the next image after about 1 second.
(Press halfway)
12
3.1
1/50
(Press fully)
SX515/EX, U (VPC-AZ3 GB) Tue. Oct., 22/2002
English
60