Smeg FP131B1 - Manual (Page 29)

61
Instructions for the installer
12.2 Positioning the oven
The oven is designed for mounting into any piece of furniture as long as it
is heat-resistant. Proceed according to the dimensions shown in Figures
1, 2 and 3. For installing under a work top, follow the dimensions given in
Figure 1-3. When installing under worktops incorporating combined hobs,
a gap of at least 110 mm must be left from any side wall, as shown in
figure 1.
When installing in tall units, comply with the dimensions shown in figure 1-2,
bearing in mind that the top/rear of the unit must have an opening 80-90 mm
deep. Tighten the 4 screws A inside the frame (fig. 1). For installing beneath
a non-integrated top, allow for a rear and bottom clearance as shown in
Figure 1 (ref. B). See relevant instructions for fitting and securing the hob.