Samsung DS-5000 - Manual (Page 32)

For the purposes of pro-
gramming speed dial num-
bers, the programmable but-
tons are known as A, B, C, D, E
and F.
• The A button is not used.
• The B button inserts a
flash.
• The C button inserts a
pause.
• The D button is used for
pulse to tone conversion. If your system uses rotary (or pulse) dialing C.O. lines,
pressing D while entering a speed dial number causes all subsequent digits to
be sent as DTMF tones.
• The E button is used to hide digits. Display keyset users may want to hide
some speed dial numbers so that they will not show in the display. When you
are entering a telephone number, press E. All subsequent digits will be hid-
den. Press E again to begin displaying digits.
• The F button is used to enter a name. See Personal Speed Dial Names under
Display Features.
• Use the HOLD button to clear a speed dial number.
ONE TOUCH SPEED DIALING
You may assign any speed dial number to an already existing One Touch Speed
Dial button for quick and easy dialing of frequently used numbers.
• While on-hook, press TRANSFER and then dial 107.
• Press a One Touch Speed Dial button.
• Dial the speed dial number (00–49 or 500–999) that you want assigned to
this button.
• Press TRANSFER to store your selection.
To call this telephone number, just press the One Touch Speed Dial button.
NOTE: If the Hot Keypad feature has been turned off, you must first lift the handset
or press the SPEAKER button before you begin dialing.
LAST NUMBER REDIAL
To redial the last telephone number you dialed, press the REDIAL button or dial 19.
NOTES:
1.
If the Hot Keypad feature has been turned off, you must first lift the handset
or press the SPEAKER button before you begin dialing.
2. Redial does not apply to intercom calls.
25
A B C D E F
ds_phones.qxp 5/11/2006 8:07 AM Page 31