Sun Microsystems Sun Fire 880 User Manual
Sun fire
Table of contents
Document Outline
- Contents
- Product Name Equivalence
- Document Revision History
- Available Online Documentation
- System Software Requirements
- Required And Recommended Software Patches
- Sun PCI Cards That Support PCI Hot-Plug
- Caution on the Use of PCI Cards Not Specifically Qualified by Sun on the Sun Fire 880 Platform
- OpenBoot Firmware Documentation
- FC-AL Disk Drive Firmware Issues
- Installing Sun Fire 880 FC-AL Backplane Firmware
- System Hang Recovery Procedure
- Supported Sun Rack for the Sun Fire 880
- Sun Fire 880 Server Rackmounting Caution Reminder
- Documentation Errata
- Correction to the Motherboard Fan Tray Removal Procedure
- Correction to the Motherboard Fan Tray Installation Procedure
- Correction to Disk Drive Installation Procedure
- Correction to FC-AL Disk Cage Installation Procedure
- Correction to FRU Part Numbers
- Correction to Cabling Instructions for Loop B PCI FC-AL Data Cable
- Correction to Expansion FC-AL Backplane Installation Procedure
- Correction to Displaying POST Results
- Correction to the diag-trigger Setting for Enabling ASR
- Correct Usage of the ifconfig Command for PCI Hot-Plug
- Correction to the Attachment Point IDs for DR Procedures
- Open Issues
- System panics if a PCI hot-plug operation is started while another operation is still in progress...
- Sun Fire 880 hardware watchdog feature does not work with Solaris 8 (BugID4374518)
- Issuing the XIR command from RSC causes the system to reset (BugID4411330)
- RSC incorrectly reports an unplugged power supply as OK (BugID4421087)
- Empty fan tray generates fault messages in the RSC event log (BugID4470063)
- Removing disk drives during hot-plugging requires devfsadm -C command (BugID4418718)
- picld died during SunVTS run, no errors reported (BugIDs4418396, 4486083)
- SunVTS dpmtest fails on dual-loop internal storage array (BugID 4487855)
- Wrong packet error seen by loopback subtest in dpmtest (Bug ID 4493252)
- prtdiag reports fan failures as ENABLED with a speed of 0 (BugID4431194)
- hsfs: hsnode table full (BugIDs4082275, 4475306)
- Intermittent picld errors during power supply hot-plug (BugID4431165)
- Sun Expert3D-Lite PCI graphics accelerator card hangs system (BugID 4474181)
- CPU/Memory slot fault LEDs do not light for overtemperature conditions (BugID4451164)
- SCSI warning when running SunVTS with an attached D1000 disk array (BugID4482342)
- Hot-plug function is not disabled when only one power supply exists (BugID4408237)
- CE memory reporting is ambiguous (BugID4491362)
- PCI Hot-plug insert message is wrong for slots 7 and 8 (BugID4546219)
- PCI attachment points should be generic (BugID4388625)
- Status LED may not shut off after PCI hot-plug (BugID4403481)