Sharp XG-PH50X - Manual (Page 23)

Introduction
-19
Using the Remote Control as a Wireless Computer Mouse
When connecting the supplied remote
mouse receiver to the computer, you can use
the remote control as the wireless computer
mouse.
1
Connect the supplied remote
mouse receiver to the USB termi-
nal on the computer.
2
Slide the ADJ./MOUSE
switch on the remote con-
trol to the MOUSE position.
3
Use the mouse function.
• Point the remote control at the remote
mouse receiver.
■ When moving the cursor
Press '/"/\/|.
■ When left-clicking
Press .
■ When right-clicking
Press .
■ When your computer supports only a
one-click mouse (such as Macintosh ® )
Press or . ( and have com-
mon function.)
ADJ.
MOUSE
Remote mouse
receiver Supplied
accessory
Note
• This function only works with the Microsoft ®
Windows ® OS and Mac OS ® . However, this
function does not work with the following op-
eration systems that do not support USB.
• Versions earlier than Windows ® 95.
• Versions earlier than Windows ® NT4.0.
• Versions earlier than Mac OS ® 8.5.
• Confirm that the computer recognizes the USB
connection.
• While the remote control is connected to the
projector with a signal cable, you cannot use
the wireless computer mouse function.
Computer
To USB terminal
Remote mouse receiver
Mouse/adjustment button ('/"/\/|)
ADJ./MOUSE switch
R-click button
L-click button