Sharp XG-PH50X - Manual (Page 19)

Introduction
-15
Projector (Side View)
Using the Kensington Lock
• This projector has a Kensington Security Standard connector for use with a Kensington MicroSaver Security
System. Refer to the information that came with the system for instructions on how to use it to secure the
projector.
Numbers in refer to the main pages in this operation manual where the topic is explained.
INPUT 1 terminal
Terminal for computer RGB
and component signals.
AUDIO input (1) terminal
Audio input terminal for
INPUT 1.
INPUT 2 terminals
BNC terminals for computer
RGB and component
signals.
INPUT 4 terminal
Terminal for connecting
video equipment.
INPUT 5 terminal
Terminal for connecting
video equipment with an
S-video terminal.
AUDIO input (4, 5) terminals
Shared audio input terminals for
INPUT 4 and 5.
RS-232C terminal
Terminal for controlling the
projector using a computer.
WIRED REMOTE terminal
For connecting the remote
control to the projector when
the signals from the remote
control cannot reach the
remote control sensor.
INPUT 3 terminal
Terminal for DVI digital RGB
and digital component signals.
OUTPUT (FOR INPUT 1, 2)
terminal
Output terminal for computer
RGB and component signals.
Shared for INPUT 1 and 2.
AUDIO input (2, 3) terminal
Shared audio input terminal for
INPUT 2 and 3.
AUDIO OUTPUT terminal
Audio output terminal shared
for INPUT 1–5.
Remote control sensor
Exhaust vent
The speed and pitch of
the cooling fan may
change during operation
in response to internal
temperature changes.
This is normal operation
and does not indicate a
malfunction.
AC socket
Connect the supplied Power
cord.
Kensington Security
Standard connector
LAN terminal
Terminal for controlling the
projector using a computer
via network.
37
17
90
35
29
36
28
36
27
27
28
35
34
18
34
34
Terminals Refer to “INPUT/OUTPUT Terminals and Connectable Main Equipment” on
page
24 .