Siemens Plant Central Clock TC100 - Manual (Page 96)

Messages
12-9 © Siemens AG 2010 All Rights Reserved
SICLOCK ® TC100 Operating Instructions
Processor has not been updated
System and
Information A processor update has been performed, but the processor could not be updated.
Hardware time set
Information The SICLOCK TC100 internal real-time clock has been set.
No usable NTP server
Information No preferred server was found.
No hardware time
Application A valid time could be read out of the hardware.
Critical temperature exceeded
Application The critical module temperature has been exceeded.
See also Temperature (Chapter 9.3.5).
Link down EHT1
Application The link status monitoring has found the status "Link down".
The triggering of an archive entry or alarm can be set with the following parameter:
/Network Settings/Ethernet 1/Extended Settings Adapter 1/Monitor Link Status
(0.05.09)
Microstep mode ignored
Application A microstep mode has been circumvented once by the user.
See also Synchronization (Chapter 9.3.2).
NTP server selected
Information A new NTP server has been selected.
NTP server unreachable
Information The server is no longer available.
A parameter has been reset to the factory setting via the HMI
Information A parameter has been reset to the factory setting via the HMI. The parameter number is
stated in the message text.
A parameter has been written via the HMI
Information A parameter has been written via the HMI. The parameter number is stated in the
message text.
Sector in the parameter memory cleaned up
System The data in the parameter memory has been cleaned up automatically.
Stabilized synchronization
Information New stabilizer data are present, and are shown in the message.
Synchronization inconsistent
Information The consistency check of an external synchronization was negative. The external
synchronization and the negatively tested offset are displayed.
Table 12-1 Overview of messages, with event type and brief description