Smeg CE6IMX - Manual (Page 21)

Instructions for the User
50
Make sure you only use containers intended for induction cooking, with a thick and completely flat
bottom or, if not available, containers without a curved bottom (concave or convex).
YES NO NO
12.5.1Cookware detector signal
Every cooking zone has a "cookware detector" that only starts the cooking if there is a well positioned
recipient with the suitable characteristics present on the burner. If the container is not well positioned or
is not made of the correct material and still tries to activate the burner, after a few seconds from the
burner's activation, the symbol will appear on the display.
12.5.2Residual heat
Each cooking zone is equipped with a residual heat warning device. After any burner is switched off, a
flashing may appear on the front zone. This warns that the cooking zone concerned is still very hot.
Cooking can be restarted even while the is flashing.
12.5.3Cooking hob lock-out
When not in use, the hob can be “locked” from being accidently turned on by children. With the burners
switched off turn the burner knobs 2 and 4 completely to the left until 5 L appears on the display. Then
release the knobs. To unlock it repeat the same operation: The burners' displays will show a 0 that will
indicate that the burners' lock has been deactivated.
12.5.4Circuit board thermal protection
The appliance is provided with a device that constantly measures the temperature of the electronic
circuit board.
If the temperature surpasses certain values, the device will activate certain functions to lower the
temperature and allow the glass-ceramic hob to continue to work correctly.
Below is a table with the operations that are activated automatically and the relative start temperature: