beautypg.com

Operating a cable box or dbs receiver, 37 operating a cable box or dbs receiver – Sony KP-41T35 User Manual

Page 37

background image

EN

37

-EN

Operations

ENTER

8

0

1

CODE SET

DBS/CABLE

FUNCTION

DBS/CABLE

FUNCTION

1

2

3

4

5

6

7

8

0

9

DBS/CABLE

3

Press DBS/CABLE (POWER) to turn on the
cable box or DBS receiver.

4

Use the cable box/DBS control buttons to
check if the code number works.
For example, to operate a cable box or DBS receiver,
you can use the DBS/CABLE (POWER), JUMP, CH
+/–, 0 – 9 and ENTER buttons.

Note

• If the cable box or DBS receiver does not have a certain

function, the corresponding button on this remote control will
not operate.

To operate the projection TV
Press TV (FUNCTION). Then use the projection TV
control buttons to control the projection TV.

For more details on operating the cable box or
DBS receiver
Refer to the operating instructions that come with the
equipment.

If the remote control doesn’t work

• First, try repeating the setup procedures using the other codes

listed for your equipment.

Manufacturer code numbers (cable box)

Notes

• If more than one code number is listed, try entering them one

by one until you come to the correct code for your equipment.

• If you enter a new code number, the code number you

previously entered at that setting is erased.

• In some rare cases, your equipment may use a code that is not

provided with this remote control and you may not be able to
operate your equipment with the supplied remote control. In
this case, use the equipment’s own remote control unit.

• Whenever you remove the batteries — to replace them, for

example — if too much time is taken, the code numbers may
revert to the factory setting and must be reset.

Manufacturer

Hamlin/Regal
Jerrold/G. I.

Oak
Panasonic
Pioneer
Scientific Atlanta
Tocom
Zenith

Manufacturer code numbers (DBS receiver)

Manufacturer

Sony

RCA

Code number

801 (preset code for the supplied

remote control)

802

Code number

222, 223, 224, 225, 226
201, 202, 203, 204, 205, 206, 207, 208,
218
227, 228, 229
219, 220, 221
214, 215
209, 210, 211
216, 217
212, 213

You can program the supplied remote control to
operate a cable box or DBS receiver. Follow the
procedures below to set the manufacturer’s code
number in the remote control.

* The TV/DBS, GUIDE, DISPLAY, V/v/B/b/

, and MENU

buttons can be used only with a DBS receiver.

1

Turn off the equipment you want to set up,
and press DBS/CABLE (FUNCTION).

2

Press the CODE SET, DBS/CABLE (FUNCTION),
and 0 – 9 buttons to enter the
manufacturer’s code number (see the chart
on the right column), then press ENTER. For
example, to program your remote control
to operate a Sony DBS receiver, press CODE
SET, DBS/CABLE (FUNCTION), 8, 0, 1, and
ENTER.

Operating a cable
box or DBS receiver

DBS/CABLE (POWER)

DBS/CABLE
(FUNCTION)

0 – 9 buttons

ENTER
GUIDE*

V/v/B/b/

*

MENU*

CH +/–

TV/DBS*

CODE SET

DISPLAY*

JUMP

This manual is related to the following products: