Siemens 3000 V3.0 - Manual (Page 22)

Putting the handset into service
14
Charging and using the batteries
To charge the batteries, insert the handset into the charging shell with the
keypad facing forwards.
The charging status is indicated by the charge status display. This flashes
during charging:
Caution:
Only use the approved C39280-Z4-C373 power supply unit for op-
erating the charging shell
(in the United Kingdom: C39280-Z4-C478).
=
Batteries empty
e
Batteries 33% charged
V
Batteries 66% charged
U
Batteries 100% charged
Note:
• Initial charging: Charge the batteries for at least 16 hours, re-
gardless of the charging status icon. Without replacing it in the
charging shell, use the handset until the "battery low" beep is
heard. This action aligns the charge status display with the op-
erating times of the batteries.
• To attain full operating and charging times ( Æ page 15): With-
out replacing it in the charging shell, use the handset until the
"battery low" beep is heard.
• For future charging: you can place your handset in the charging
shell each time it is used. Charging is electronically controlled
which ensures that the batteries are charged optimally.