Siemens 3000 V3.0 - Manual (Page 21)

Putting the handset into service
13
Putting the handset into service
Removing the protective cover
Inserting the batteries
Two batteries are provided with the handset. The batteries are supplied un-
charged. They are charged in the handset.
Opening the battery compartment
Press down on the ridged surface and slide the cover from the battery
compartment.
Inserting batteries
Insert the correct batteries according the the pole directions as marked.
Closing the battery compartment
Put the cover back in place and slide it onto the battery compartment until
it engages.
Remove the protective cover from the display before
putting the handset into service.
Note:
• Please observe the safety notes on the back cover.
• Only use approved batteries ( Æ page 15).
• Always replace both batteries at the same time and only use
two batteries of the same type/ from the same manufacturer!
• Open the battery compartment in a dust-free environment only.
• Your telephone directory entries and all settings remain stored
even if you remove the batteries. The date and time settings
will be reset.
• Only remove the batteries if they are defective. Any unneces-
sary removal of the batteries reduces their lifespan.