SMC Networks SMC9462TX User Manual
Page 27
I
NSTALLING
AND
C
ONFIGURING
N
ETWORK
D
RIVERS
2-7
8. A screen with three dialog boxes is displayed. To change the
driver configuration, tab to the “SMC9462_1 Parameters” dialog
box and modify the driver parameters. Depending on the
network that the card is attached to, the Link, Speed, Duplex
Mode, and Phy Type parameters might need to be changed
from their default values. If you are not sure what values are
required for your network, contact your network administrator.
9. Tab to the “SMC9462_1 Protocols” and select the desired
protocols.
10. Tab to the “Board SMC9462_1 Actions” dialog box. Select the
“Save Parameters and Load Driver” option and press Enter to
continue.
11. Perform protocol specific configuration as required.
12. Select “No” when asked if you want to load additional drivers.
13. On the “Additional Driver Actions” dialog box, select “Return to
previous menu” and press Enter to continue.
14. On the “Driver Options” dialog box, select “Return to previous
menu” and press Enter to continue.
15. On the “Installation Options” dialog box, select “Exit” to return
to the NetWare console prompt.