Samsung D372WH(i) - Manual (Page 16)

ENGLISH
16 16
Preparation
Using the Lithium Ion Battery Pack
✤ Use SB-LSM80 or SB-LSM160 Battery Pack only.
✤ The Battery Pack may be charged a little at the time of purchase.
Charging the Lithium Ion Battery Pack
1. Turn the [Power] switch to [OFF].
2. Attach the Battery Pack to the Camcorder.
3. Connect the AC Power adapter (AA-E9 TYPE) to a wall
socket.
4. Connect the DC cable to the DC jack on the
Camcorder.
■ The charging indicator will start to blink, showing that
the Battery is charging.
5. Press and hold the DISPLAY button while charging and the charging status will be displayed
on the LCD screen for 7 seconds.
■ The battery charge status is given as reference and is an estimation. It may differ
depending on the Battery capacity and temperature.
6. When the Battery is fully charged, disconnect the Battery Pack and the AC Power Adapter
from the Camcorder.
Even with the Power switched Off, the Battery Pack will still discharge.
Charging, Recording Times based on Model and Battery Type.
✤ The continuous recording times given in the table to the right are
approximations.
Actual recording time depends on usage.
✤ The continuous recording times in the operating instructions are
measured using a fully charged Battery Pack at 77 °F (25 °C).
✤ Even when the Power switched Off, the Battery Pack will still
discharge if it is left attached to the device.
Battery Info
B Ba atttte erryy cch ha arrg ge ed d
0% 50% 100%
Blinking time Charging rate
Once per second Less than 50%
Twice per second 50% ~ 75%
Three times per second 75% ~ 90%
Blinking stops and stays on 90% ~ 100%
On for a second and Error - Reset the Battery Pack and
off for a second the DC Cable
Battery
SB-LSM80
SB-LSM160
(Option)
Charging time
Approx.
1hr 20min
Approx.
3hr
Recording time
Time
Approx.
1hr 20min
Approx.
2hr 40min
01227G VPD371 UK~022 2/1/07 12:02 PM Page 16