Sony SRX-S105 - Manual (Page 61)

61
Connecting the Projector
Cha
p
te
r 2
P
repa
ra
ti
ons
Connecting the Projector
When you connect the projector, make sure to:
• Turn off all equipment before making any connections.
• Use the proper cables for each connection.
• Insert the cable plugs firmly; loose connections may
increase noise and reduce performance of picture
signals. When pulling out a cable, be sure to pull it out
from the plug, not the cable itself.
• When installing the optional input board, consult your
Sony dealer.
Refer also to the instruction manuals of the equipment to
be connected.
Connecting a Computer Equipped
With a DVI Connector
Connect a computer equipped with a DVI connector to the
DVI-D connectors on INPUT A of the projector, or those
on the optional LKRI-004 interface board attached to the
input board attachment part. A progressive DVI signal can
be input.
The illustration below shows an example in which the
connection is made using INPUT A on the projector.
• According to the input signal type, set “Signal Mode” on
“Input Source” in the PICTURE CONTROL window of
the SRX Controller. (page 69)
• When an extension cable is used, the signal may not be
input correctly due to signal reduction.
• If you input 10-bit signals from a DVI-D connector only
(10-bit single mode), a DVI cable compatible with the
Dual-link is required.
Notes
INTER LOCK ETHERNET RS232C
AUX DVI-D
Left side
DVI-D connector AUX connector
DVI cable
(not supplied)
to DVI output
Computer