Screen control window – Sony SRX-S105 User Manual

Page 51

Location and Function of Controls

Chapt

er 1 Ov

c Information window

Location: Shows the location where the projector is

installed, as set in the SETTING window at the time
of installation.

Name: Shows the name of the projector that was set in the

SETTING window at the time of installation.

Operation Timer: Shows the operation hours of the

projector.

Lamp A/Lamp B: Shows an approximate percentage to

indicate the time used before the recommended time
for replacement of each projection lamp (i.e. 100%
indicates the time for replacement). The indicator on
the left lights when the corresponding lamp turns on.
It does not light when the corresponding lamp turns
off.

Warning Info: Displays an error message if there is any

warning information on the projector. The same
message is displayed in the STATUS MESSAGE
window on the left side of the projector.

d POWER ON/STANDBY (?/1) buttons and

POWER indicator

Click ON to turn on the lamp. The indicator lights green.
Clicking STANDBY opens the confirmation dialog.
Clicking “OK” makes the projector enter standby mode.
The indicator flashes green. Even in standby mode, the
fans continue to run to reduce internal heat. When the fans
stop running, the indicator lights red.

e FUNCTION 1 to 7 radio buttons
Register the data set or adjusted in the Control Function
Menu windows to these buttons, and recall it later to
project an image with that setting.
The setting items that can be registered are as follows:
• Screen mode and input signal settings in the SCREEN

CONTROL window

• “Input Source” and “Signal Adjust” settings in the

PICTURE CONTROL window

• “Color” settings in the COLOR/FRAME window
• “ELECTRIC V SHIFT FUNCTION,” “SQUEEZE,”

“PROGRESSIVE DISPLAY MODE,” “LAMP
POWER” and “LAMP SELECT” settings, and “LENS
CONTROL” settings when the optional lens equipped
with zoom/focus memory function is installed, in the
INSTALLATION window

For details, see “To register the settings that have been
adjusted” on page 68.

f Window select buttons
Open the window with the items you want to set or adjust.

g Adjustment/setting window
Clicking the window select button switches the window
for the adjustment and setting.
The “PICTURE CONTROL,” “COLOR/FRAME” and
“INSTALLATION” windows can be displayed.

For details on each window, see “Adjustments and
Settings Using the SRX Controller” on page 68.

SCREEN CONTROL window

a Screen mode buttons
Select single-, dual- or quad-screen mode for multiple
display mode. Click

for single,

for dual and

for quad mode.

b CUT OFF “ON/OFF” buttons
Click the ON button to cut off the picture momentarily.
Click the OFF button to restore the picture.
The SCREEN CONTROL window changes depending on
the screen mode selected with the screen mode button (1).
When dual- or quad-screen mode is selected, the buttons
function independently on each divided screen.

c Input signal select drop-down list box
Selects the input signal you want to project on the screen.
The SCREEN CONTROL window changes depending on
the screen mode selected with the screen mode button (1).
When dual- or quad-screen mode is selected, you can
select the input independently on each divided screen.
INPUT A: Selects the signal input from the DVI-D

connectors on INPUT A.

INPUT B: Selects the signal input from the connectors on

the optional input board installed in the INPUT B
section.

INPUT C: Selects the signal input from the connectors on

the optional input board installed in the INPUT C
section.

INPUT D: Selects the signal input from the connectors on

the optional input board installed in the INPUT D
section.