Sony SRX-S105 - Manual (Page 58)

58
Connecting a Computer for Controlling the Projector
Chap
te
r 2
Pr
epa
ra
tio
n
s
Connecting a Computer
for Controlling the
Projector
Connect a computer for controlling the projector to the
projector via the ETHERNET connector or the RS232C
connector.
Connecting the Computer via the
Ethernet
Connect the computer to the projector using the supplied
ethernet cable (cross cable).
Set the TCP/IP protocol of the connected computer to
DHCP.
For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port.
Follow the instructions for this port.
Par mesure de sécurité, ne raccordez pas le connecteur
pour le câblage de périphériques pouvant avoir une tension
excessive à ce port.
Suivez les instructions pour ce port.
Aus Sicherheitsgründen nicht mit einem Peripheriegerät-
Anschluss verbinden, der zu starke Spannung für diese
Buchse haben könnte.
Folgen Sie den Anweisungen für diese Buchse.
If the power of the projector remains on for a long period
of time without the Ethernet cable connected, the message
“Sony SR Projector Initializing…” may appear in the
STATUS MESSAGE window while you are setting up for
networking after connecting the Ethernet cable. This is not
a malfunction of the projector.
Note
R(P r /C r ) B(P b /C b ) HD VD G(Y/Y)
IN
INTER LOCK ETHERNET RS232C
OUT
IN OUT
AUX DVI-D
ETHERNET connector
Ethernet cable (cross cable)
(supplied)
Computer
Ethernet connector
CAUTION
ATTENTION
ACHTUNG
Note