Sharp MD-MT877H - Manual (Page 21)

21
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)
Basic Operation
– Recording –
Recording : continued
Notes:
● When recording, it is recommended to use the AC
adopter and also install the charged battery. Should the
power failure occur, the power source would be auto-
matically switched to the rechargeable battery.
● Changing the volume level whilst recording does not af-
fect the recording.
● You cannot adjust the bass level whilst recording.
1
Press the REC button.
● Record pause mode is entered.
● The REC button does not light.
2
Begin playback on the stereo system con-
nected to this portable MD.
● To enable the record level to be set.
3
Press the
5 5 5 5 5
or
4 4 4 4 4
button to adjust the
recording level.
Analogue recording
● Adjust the recording level so that the maximum
sound volume from the source makes the read-
ing swing somewhere between –4 dB and 0 dB.
0dB
4dB
Digital recording
● You can adjust the level in 1 dB increments within
the range of +12 - –12dB.
● Once you adjust the digital recording level, the
setting remains even after the recording stops.
(For cancellation instructions, see page 41.)
4
Press the PAUSE button on the stereo sys-
tem to enter the playback pause mode at
the point you wish to start recording.
● Here you can select the track to be recorded.
5
Press the MODE button repeatedly to se-
lect recording mode.
( stereo recoding)
( 2 times long recording)
( 4 times long recording)
( monaural recording)
6
Press the
06 06 06 06 06
button to start the MiniDisc
unit recording.
7
Begin playback on the stereo system, the
output will be recorded.
Level meter indicator
+12 - –12dB