Sharp MD-MT877H - Manual (Page 13)

DEUTSCH
FRANÇAIS
ESPAÑOL
SVENSKA
ITALIANO
NEDERLANDS
ENGLISH
13
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)
Caution:
● Use the specified battery AD-N55BT only. Do not charge
a battery (nickel-cadmium, alkaline, etc.) other than that
specified.
● Do not remove the outer cover of the re-
chargeable battery. It may cause heat gen-
eration, fire, or explosion.
● Do not dip the battery in water, do not dis-
pose of it in a fire, and do not take it apart.
● If the rechargeable battery terminal is dirty, charging may
not start. In such a case, wipe off the dirt with a dry cloth.
● Do not disassemble the battery.
About Power Source : continued
About the liquid crystal display (LCD)
The condition of the portable MD will be shown on the LCD
when inserting it into the battery charger.
Display Conditions
Scrolling
● Charging.
Turns off
● The charging is complete.
● When the portable MD is not in-
serted correctly to the battery
charger, or
Rechargeable terminal is dirty, it
may not be possible to charge the
battery. (Wipe the terminal by cot-
ton swab.)
● Refreshing (see page 41).
The unit checks and, if necessary,
discharge the rechargeable bat-
tery to recharge it automatically.
(At this time battery indicator is
flashing.)
About charging time
After about 3.5 hours have passed, “ ” will go out.
The battery is charged up to 95% if it is completely
discharged.
Notes:
● Charge the battery within the range of 5 ° C - 35 ° C (41 ° F
- 95 ° F).
● The unit can be left in the charging state after it is com-
pleted.
● If the MiniDisc unit is not to be used for some time,
remove the battery. (The battery drains gradually even
when the power is turned off.)
● Carry the battery in the supplied case.
Power Source
– Using with the Rechargeable Battery –