Instructions for the user – Smeg SCA708X User Manual

Page 11

Instructions for the user

Cooking start: as well as setting a cooking duration time, the user can
also set the cooking start time (up to 12 hours after the current time). To
set the cooking start/end time, proceed as follows.

-

Set the cooking duration time as described in the previous point.

Within 6/7 seconds after the last time the

keys are

pressed, press the

key to set the cooking start time. The display

will show the current time with the inside segments indicating the

cooking end time illuminated. Use the

and

keys to set the

cooking start time.

6/7 seconds after the last time a key is pressed, the display will
show the current time and the cooking start and end times, indicated
by the illuminated inside segments. The segments on the display
will be constantly on until the current time is the same as the
cooking start time; as soon as the current time reaches the cooking
start time set, all the inside segments will start to flash, indicating
that the oven has started cooking.

When the end of the cooking time is reached, the timer will switch
off the oven heating elements, the beeps will start and the numbers
on the dial will flash.

To reset the entire program set, keep the central key

pressed for

1 or 2 seconds

if cooking has already started the oven will have to

be switched off by hand.

The image on the right shows an example of
programming: the current time is 7.06 and
cooking is programmed to start at 8 o'clock
and finish at 9.

At 8 o'clock, the inside segments between 8
and 9 will start to flash and the hour pointer will
remain still.

Caution: for the oven to start cooking after the programming procedure
just described, the thermostat and function selector must be properly set
on the temperature and function required.

3.2.4 "DEMO" Function
Models with analogue/digital programmer feature a "DEMO" function
which deactivates the heating elements while leaving the other functions

unchanged. To activate it, simply press the

and

keys and keep

them held down for 3/4 seconds. A confirmation buzzer will inform the user
that the function is active. When the “DEMO” function is active, the
number 6 on the clock flashes at regular intervals. To deactivate it, simply
repeat the same procedure.

This manual is related to the following products:

SCA705X SCA710X