Siemens BACNET 125-699 - Manual (Page 33)

Point Database
Siemens Building Technologies, Inc. 25
Description Address Application Description
HTG LOOPOUT {80} 2583, 2584 Heating temperature control loop output value in percent.
ELEC HEAT ON 81 2584 Value, in percent, that the heating Ioopout must exceed for
the electric heat to turn ON.
EHEAT 1 ON 81 2583 Value, in percent, that the heating loopout must exceed for
the first stage of electric heat to turn ON.
CMP1 ON 82 2583 Value, in percent, that the active temperature control
loop output must exceed for compressor 1 to turn ON.
Actual turn on is subject to the CMP MlN OFF time being
expired. lt is also the value, in percent, which HTG
LOOPOUT must go below for the electric heat (ELEC HEAT
1) to turn OFF when only one compressor is used.
HTG CMP1 ON 82 2584 Value, in percent, that the heating temperature control loop
output must exceed for heating compressor 1 to turn ON.
Actual turn on is subject to the HTG1 MlN OFF time being
expired.
CMP1 OFF 83 2583 Value, in percent, that the active temperature control loop
output must go below for compressor 1 to turn OFF. Actual
turn off is subject to the CMP1 MlN ON time being expired.
HTG CMP1 OFF 83 2584 Value, in percent, that the heating temperature control loop
output must go below for heating compressor 1 to turn OFF.
Actual turn off is subject to the HTG1 MlN ON time being
expired.
RVAL SWITCH 84 2583 Value, in percent, that the active temperature control loop
output must go above for the reversing valve to switch.
Actual switchover is subject to the status of HEAT.COOL,
RVAL SW TIME, and HTG LOOPOUT or CLG LOOPOUT.
SWITCH LIMIT 85 2583, 2584 Active temperature control loop output must be less than
this value to switch between cooling mode and heating
mode. Actual switchover depends on SWITCH DBAND
being exceeded and is subject to SWITCH TIME being
expired.
SWITCH TIME 86 2583, 2584 Time, in minutes, that must expire to switch between cooling
mode and heating mode. Actual switchover depends on the
active temperature control loop being below the value of
SWITCH LIMIT and exceeding the value of SWITCH
DBAND.
CMP1 MlN OFF 87 2583 Minimum time, in minutes, that compressor 1 will remain
OFF before turning ON.
HTG1 MlN OFF 87 2584 Minimum time, in minutes, that heating compressor 1 will
remain OFF before turning ON.
CMP1 MlN ON 88 2583 Minimum time, in minutes, that compressor 1 will remain ON
before turning OFF.
HTG1 MlN ON 88 2584 Minimum time, in minutes, that heating compressor 1 will
remain ON before turning OFF.
RVAL SW TIME 89 2583 Length of time the compressor must be OFF before the
reversing valve can switch modes.