Spectra Logic RXT150 - Manual (Page 20)

Chapter 2. Troubleshooting the RXT150
20
Resetting the RXT150
Resetting the RXT150 allows a soft reboot of the drive.
Caution: Never reset the drive while data is being written to RXT media.
Only reset the drive on the recommendation of SpectraGuard
Technical Support. A drive reset erases valuable log information
that SpectraGuard Support staff can use to diagnose problems.
Proceed to one of the following:
• Resetting the RXT150 with the Digital Display, below
• Resetting the RXT150 with the Serial Interface on page 21
Resetting the RXT150 with the Digital Display
Select
Load/
Unload
Display
1. Make sure that an RXT media pack is not loaded.
2. Make sure that the display is in ready mode; the display
blank is and the LED in the lower right corner flashing
slowly and steadily.
3. Press Select to display A , then press Load/Unload
repeatedly to
display
J .
4. Press Select to continue with the task. The next character
to
display is a question mark (
? ).
5. Press Load/Unload; an N for No displays.
6. Press Load/Unload; a Y for Yes displays; press Select.
The reset takes several minutes. During this time, the display shows a
sequence of characters, then the RXT150 reboots. The RXT150 is
reset and ready to use when the display returns to ready mode.