Select Comfort Precision Comfort Adjustable Foundation - Manual (Page 19)

Precision Comfort™ Owners Manual
19
PROGRAMMING 2 hand controls - 1 bed
The three step procedure below is required to program 2 hand controls to operate 1 bed.
Before beginning, make certain the bed is plugged into a working grounded electrical
outlet.
STEP 1
Locate the power down box for the bed
and press the learn button for 1 second
and release (FIGURE 16).
STEP 2
On hand control 1, simultaneously press
and hold the POS 1 and the head massage
on/off buttons (FIGURE 17). The
transmission indicator light will flash
slowly and then flash rapidly. Continue to
hold for 5 seconds and then release the
buttons.
STEP 3
Repeat Step 1 and Step 2 with hand
control 2.
Two hand controls are now programmed
to operate one bed.
HAND
CONTROL 1
HAND
CONTROL 2
IF PROGRAMMING FAILS, INITIATE THE
PROGRAMMING PROCEDURE A SECOND
TIME.
NOTE
LEARN
BUTTON
FIGURE 16: Power down box learn button.
POWER
DOWN BOX
POS 1
BUTTON
TRANSMISSION
INDICATOR LIGHT
FIGURE 17
HEAD MASSAGE
ON/OFF BUTTON