Symbol Technologies DS 6608 - Manual (Page 53)

User Preferences 4-11
Beep After Good Decode
Parameter # 38h
Scan a bar code below to select whether or not the digital scanner beeps after a good decode. If selecting Do Not Beep After Good
Decode, the beeper still operates during parameter menu scanning and to indicate error conditions.
Scanstand Session Timeout
Parameter # F0h, 90h
To set the amount of time the digital scanner attempts to decode a bar code in hands-free mode (blink mode), scan the bar code below.
Next, scan three numeric bar codes from Appendix D, Numeric Bar Codes to select a value between 1 and 255 that represents tenths
of a second. Single digit numbers must have a leading zero. For example, to set 0.5 seconds, scan the bar code below, then scan the
0, 0, 5 bar codes. To correct an error or change the selection, scan Cancel on
page D-4. The default value is 2 seconds.
*
Beep After Good Decode
(Enable)
(01h)
Do Not Beep After Good Decode
(Disable)
(00h)
Scanstand Session Timeout