Sharp XG-PH70X - Manual (Page 101)

Appendix
-99
To AC socket
Power cord
ON button
ENTER button
MENU button
H&V LENS
SHIFT
button
Resetting the Lamp Timer
Reset the lamp timer after replacing the lamp.
Info
• Make sure to reset the lamp timer only
when replacing the lamp. If you reset the
lamp timer and continue to use the same
lamp, this may cause the lamp to become
damaged or explode.
1
Connect the power cord.
• Plug the power cord into the AC socket
of the projector.
2
Reset the lamp timer.
For Lamp 1
• When you reset the timer for AN-
PH7LP1, while simultaneously holding
down and , press on the
projector.
• “LAMP 1 100%” is displayed, indicating
that the lamp timer is reset.
For Lamp 2
• When you reset the timer for AN-
PH7LP2, while simultaneously holding
down and , press on the
projector.
• “LAMP 2 100%” is displayed, indicating
that the lamp timer is reset.