Sharp XL-DV60 - Manual (Page 54)

54
XL-DV60
Re
fe
re
nces
Maintenance
" Cleaning the laser pickup lens
In order to ensure proper operation of the DVD player, preventative
maintenance (cleaning of the laser pickup lens) should be per-
formed periodically. Lens cleaners are commercially available. Con-
tact your local DVD software dealer for options.
" Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth and a diluted soap
solution, then with a dry cloth.
Caution:
! Do not use chemicals for cleaning (gasoline, paint thinner, etc.). It
may damage the cabinet finish.
! Do not apply oil to the inside of unit as this may cause malfunc-
tions.
" Care of discs
Discs are fairly resistant to damage, however mistracking can occur
due to an accumulation of dirt on the disc surface. Follow the guide-
lines below for maximum enjoyment from your disc collection and
player.
! Do not write on either side of the disc, particularly the non-label
side from which signals are read. Do not mark this surface.
! Keep your discs away from direct sunlight, heat, and excessive
moisture.
! Always hold the discs by the edges. Fingerprints, dirt, or water on
the discs can cause noise or mistracking. If a disc is dirty or does
not play properly, clean it with a soft, dry cloth, wiping straight out
from the center, along the radius.
Specifications
As part of our policy of continuous improvement, SHARP reserves
the right to make design and specification changes for product
improvement without prior notice. The performance specification fig-
ures indicated are nominal values of production units. There may be
some deviations from these values in individual units.
" General
" Amplifier
NO YES
Correct
Power source AC 120 V, 60 Hz
Power consumption 116 W
Dimensions Width: 6-5/16" (160 mm)
Height: 9-7/16" (240 mm)
Depth: 12-9/16" (319 mm)
Weight 12.3 lbs. (5.6 kg)
Output power Front speakers: 37.5 watts minimum RMS
per channel into 6 ohms from 100 Hz to 20
kHz, 10% total harmonic distortion
Subwoofer: 45 watts minimum RMS into 6
ohms from 70 Hz to 130 Hz, 10% total
harmonic distortion
Audio output
terminals Front speakers and subwoofer: 6 ohms
Headphones: 16 - 50 ohms
(recommended: 32 ohms)
Optical digital output: Square type 1
Audio input
terminals Video/Auxiliary (audio signal): 500 mV/47 k
ohms
Video output
terminals Video output: RCA type 1
S-video output: S-terminal 1
Component video output: RCA type 3
(Pr/Cr, Pb/Cb, Y)