Sony SVR-S500 - Manual (Page 10)

SVR-S500
2-689-634-11(1)
10
D:\DVR project\Instruction
manual\DTP\2689634111\GB04BAS-CEK.fm
master page=left
Step 3: Connecting the Audio Cords
You can improve sound quality by connecting a stereo system to the AUDIO OUT R-L jacks as shown
below.
z Hint
For correct speaker location, see the operating instructions supplied with the connected components.
Step 4: Connecting the Mains Lead
1
Plug the cable attached to the AC adapter 1 into the DC In connector 2 on the recorder.
2
Plug one end of the power cord 3 into the AC adapter.
3
Plug the other end of the power cord into the mains.
Then plug the recorder and TV mains leads (power cords) into the mains.
After you connect the mains lead, you must wait for a short while before operating the
recorder. You can operate the recorder once the front panel display lights up and the recorder enters
standby mode.
If you connect additional equipment to this recorder (page 9), be sure to connect the mains lead after all
connections are complete.
Audio cord (not supplied)
to AUDIO L-R
Hard disk recorder
to Line IN
to mains
to DC IN 12V
1
2
3
AC Adapter Power Cord
Hard disk
recorder