Sony STR-DN1000 User Manual
Page 89
89
US
A
m
p
lif
ie
r O
p
e
ra
tio
n
s
Tips
• Operations other than turning the receiver on or off
are deactivated during Auto Calibration.
• The measurements may not be performed correctly
or Auto Calibration cannot be performed when
special speakers, such as dipole speakers are used.
To confirm/save Auto
Calibration when GUI function
is turned off
1
Confirm the measurement result.
When the measurement ends, a beep
sounds and the measurement result appears
on the display.
2
Press
V/v repeatedly to select the item,
then press
.
3
Select “SAVE EXIT” in step 2.
The measurement results are saved.
4
Press
V/v repeatedly to select the Auto
Calibration Type, then press
.
Tip
The size of a speaker (LARGE/SMALL) is
determined by the low frequency characteristics.
The measurement results may vary, depending on
the position of the optimizer microphone and
speakers, and the shape of the room. It is
recommended that you follow the measurement
results. However, you can change those settings in
the Speaker settings menu. Save the measurement
results first, then try to change the settings if you
want.
Measurement
result
Display
Explanation
When the
measurement
process
completes
properly
COMPLETE Proceed to step
2.
When the
measurement
process fails
E -
xxx
:
xx
See “Message
list after Auto
Calibration
measurement”
(page 44).
Item
Explanation
RETRY
Performs the Auto
Calibration again.
SAVE EXIT
Saves the measurement
results and exits the setting
process.
WARN CHECK Displays a warning
concerning the measurement
results. See “Message list
after Auto Calibration
measurement” (page 44).
PHASE INFO.
Displays the phase of each
speaker (in phase/out of
phase). See “When you select
“PHASE INFO.”” (page 90).
DIST. INFO.
Displays the measurement
result for speaker distance.
LEVEL INFO.
Displays the measurement
result for speaker level.
EXIT
Exits the setting process
without saving the
measurement results.
Auto
Calibration
Type
Explanation
FULL FLAT
Makes the measurement of
frequency from each speaker
flat.
ENGINEER
Sets the frequency
characteristics to a set that
matches that of the Sony
listening room standard.
FRONT REF
Adjusts the characteristics of
all the speakers to match the
characteristics of the front
speaker.
OFF
Set the Auto Calibration to
off.
Item
Explanation
continued