Getting started, Setting up the hardware, Setting up the network – Samsung CLP-350 User Manual
Page 18: Setting up the hardware setting up the network
3
.1
3
Getting Started
This chapter gives you step-by-step instructions for setting up the
machine.
This chapter includes:
•
•
•
•
Setting up the hardware
This section shows the steps to set up the hardware which is explained
in the Quick Install Guide. Make sure you read Quick Install Guide and
complete following steps.
1
Select a stable location.
Select a level, stable place with adequate space for air circulation.
Allow extra space to open covers and trays.
The area should be well-ventilated and away from direct sunlight or
sources of heat, cold, and humidity. Do not set the machine close to
the edge of your desk or table.
Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to
the altitude setting to optimize your printing. See page 3.4 for more
information.
Place the machine on a flat and stable surface for not letting it tilt
more than 2 mm (0.08 inches). Otherwise, it may affect the printing
quality.
2
Unpack the machine and check all the enclosed items.
3
Remove the tape holding the machine tightly.
4
Install both the toner cartridge.
5
Load paper. (See "Loading paper" on page 4.4.)
6
Make sure that all the cables are connected to the machine.
7
Turn the machine on.
Caution
When you move the machine, do not tilt or turn it upside
down. Otherwise, the inside of the machine may be
contaminated by toner, which can cause damage to the
machine or bad printing quality.
Setting up the network
You need to set up the network protocols on the machine to use it as your
network printer.
Note
• If you want to use the USB cable, connect the cable between a
computer and you machine. Then, refer to the software
installation in Software section.