Southbend STRG-5D - Manual (Page 24)

S ERVICE S TRATO S TEAM C OUNTERTOP S TEAMER
Figure 11
Steamer Not Heating Up, “Power” Light Is Not Lit
Steamer not heating up, “Power” light not lit.
DISCONNECT POWER AT CIRCUIT BREAKER
Remove right side panel for access.
Reconnect power at circuit breaker.
Turn lever to “ON” position and close door (to actuate door switch).
DISCONNECT POWER AT CIRCUIT BREAKER Test operation of power switch. Replace if necessary. If power
switch is OK, replace “Power” light and follow procedure.
Replace Power Cord Check continuity across
Power Switch
Is continuity
present?
No
Check voltage between TB5 and TB6
Yes
Check continuity between cord and TB5 and TB6
No Yes
Is measured
voltage 120, 208, 220, or 240
volts?
Is continuity
present?
No Yes
Replace Power Switch Replace Power Light
P AGE 24 OF 50 O WNER ’ S M ANUAL 1185290