Sunwave Tech. 3815 - Manual (Page 58)

SRC-38 SERIES User’s Manual
52
One or more devices
do not respond in RF
mode.
When operating properly, the red LED
light on the front of the IR-extender will
blink while sending or receiving signals. To
test IR-extender:
1. Press Remote Locator button.
2. Use remote in RF mode.
LED should blink during each test.
RF addresses for device(s) and IR-
extender may not set to the same
setting. Check setting on each and reset
of needed.
Check to make sure SRC-3815 is set to
operate in RF mode.
IR-extender is not aimed at desired
device. Reposition IR-extender.
No AC power to IR-extender. Make sure
AC adapter is plugged in.
Batteries may be low in remote. Change
batteries if needed.