Sunwave Tech. 3815 - Manual (Page 27)

Code Menu
21
Learning from Another Remote Control
Before using learning mode, set both remotes on a flat
surface so that the device’s remote control IR is
pointed at the SRC-3810/3815’s learning eye, which is
located at the bottom of the unit.
1. Press or to select Learn .
2. Press .
3. Point the target device's remote
control’s infrared eye at the SRC-
3810/3815 learning eye located at
the bottom of the unit (see Figure 1:
Front View, Page3) and keep apart
between 2~4 inches (5~10cm).
4. Press the button corresponding to the target device.
The SRC-3810/3815 Touch Screen sequentially displays screens
corresponding to first the hard keys, then page one of the soft
keys, and finally page two of the soft keys. The blinking
rectangle denotes the key being learned.
5. Press the corresponding button of
the target device's remote control.
The SRC-3810/3815 screen displays
an OK message if the code was
successfully learned or an ERROR
message if the code was not
learned.
Press to toggle between hard
and soft key displays.
Note: When the remote has
learned the last button on the
page, the next page is
automatically displayed.
6. Press to exit learning mode.