Sunwave Tech. 3815 - Manual (Page 25)

Code Menu
19
Note: Some codes are designed to operate more than one
model. It may take several tries to find the code that works
with your unit.
6. Press to confirm the selection and save the settings or
click to exit.
Note: When you enter the Manufacture Code and an
'ERROR’ message is displayed, it could be for two reasons:
1. That code number doesn't exist in the Manufacture
Code table yet.
2. That code number is not in the range of the
Manufacture Code table reserved for the default
device screen
Selecting a Code Automatically
1.
Turn on the target device
you want the SRC-3810/3815
to control.
2. Press the device hardware
button (for example TV).
3. Point the SRC-3810/3815 at
the target device.
Press the AUTO button. An
“AUTO” message displays
while the SRC-3810/3815
automatically cycles through
the codes. Wait for the
device to turn on and then
press the POWER button or
AUTO key to stop the
automatic search.
The last tried code is displayed in the upper right-hand
corner. Test this code by pressing the POWER button .
If it doesn't work, you may need to press the tuning down
key
and try a few of the previously scanned codes.
4. Press to confirm the selection and save the settings or
click to exit.