Smeg ALFA41XEN - Manual (Page 12)

Instructions for the User
Press STOP to move on to setting the minutes.
Press START to increase the minutes.
Press STOP to complete the program editing procedure.
The display shows UEnd.
The parameters set are now saved in the chosen program.
4.10
How "programmed preheating" works
If the above parameters are set correctly, and only if the knob is set
on P9, the oven will run the preheating program every day at the set time;
during the preheating the display will show the "PrEh" message, and
once the set temperature is reached it will be kept constant until the
switch off (OFF) time set, or until the user interrupts it by pressing
the STOP button.
After STOP has been pressed, the oven is ready to run any cooking
program.
4.11
Possible error messages on the display
The display is able to show two different types of error
Err1 = probe failure
Err2 = low voltage : less than 160 volts.
4.12
Technical notes
If the power supply to the appliance fails at any time, always return the
knob to the 0 setting before running any programs.
30