Sharp Aquos LC 26GD4U - Manual (Page 58)

57
Using external equipment
Setting the recording mode (i.LINK)
• The function for automatically adjusting the recording
mode of connected D-VHS decks can be turned on
or off.
• Since most of the currently available D-VHS decks
automatically recognize the transfer rates of the
pictures and sound being recorded and control the
recording mode accordingly, you should always set
this Mode to “No” in normal circumstances.
• Depending on the D-VHS deck used and the type of
broadcast being recorded, this TV may not adjust
the recording mode properly. In this case, please
set the “Recording Mode” to “No”.
Press MENU and the MENU screen displays.
Press c/d to select “Digital Setup”.
Press a/b to select “i.LINK Setup”, and then
press ENTER.
1
2
3
Press a/b to select “Recording Mode”, and
then press ENTER.
4
Press c/d to select “Yes” or “No”, and then
press ENTER.
• Normally, this should be set to “No”.
5
Setting the Stand-by Mode (i.LINK)
• Power consumption during stand-by mode can be
minimized by changing the setting of the “Standby
Mode” in “i.LINK Setup”.
• When i.LINK is not in use, select “No” in “Stand-by
Mode”.
Press MENU to display the MENU.
Press c/d to select “Digital Setup”.
Press a/b to select “i.LINK Setup”, and then
press ENTER.
1
2
3
Press a/b to select “Stand-by Mode”, and
then press ENTER.
4
Press c/d to select “Yes” or “No”, and then
press ENTER.
5
“Yes”: Power continues to pass through the i.LINK
circuit so data can be relayed.
“No”: Power consumption is minimized during stand-
by mode. Data cannot be sent at this setting.
NOTE
• When the main power of the TV is in standby mode
(POWER indicator lights up in red), i.LINK control
commands cannot be received from a D-VHS deck. This
does not change even if the “Stand-by Mode” is set to
“Yes”. To control the TV from a D-VHS deck, turn the TV
power on (POWER indicator lights up in green).
• Data cannot be relayed between i.LINK devices when all
the following conditions are met: 1) More than one i.LINK
device is connected to the TV with i.LINK cables, 2)
“Stand-by Mode” is set to “No”, and 3) The main power of
the TV is in standby mode (POWER indicator lights up in
red). When the TV is connected between two i.LINK
devices in series, select “Yes” in “Stand-by Mode” or
connect the TV at an end of the series as shown in the
diagram.