Sharp Aquos LC 26GD4U User Manual

Page 48

Using memory card

Recording a motion picture

Use this setting to record images you are currently
watching.
Record with the settings made in “Rec. Mode” and
“Pre Record”.

Press REC to start recording.

• CARD indicator lights up red.
• Recording information displays in the lower

right corner of the screen.

Press

H to stop recording.

To display the remaining record time.

Press DISPLAY while not recording.

• Remaining record time displays in the lower right corner

of the screen.

NOTE

• Do not remove the AC cord from the socket.
• Recording stops if you press POWER on the remote

control while recording.

• When card has no capacity for recording, “Card is full”

displays and stops recording.

• You cannot change the channel or switch the input source

while recording.

Displaying a motion picture

Press CARD and the card mode screen
displays.

Press c/d to select “Video”, and then press
ENTER.

Press a/b/c/d to select the file you want
to play, and then press ENTER.

• Video playback starts.

Press CARD again to display the operation
panel.

• See page XX for the operation panel

information.

• When viewing a motion picture, by pressing

VIEW MODE the picture size changes.
Small – Medium – Large.

NOTE

The list of broadcasting type or input signal not available
for recording:
1 COMPONENT input
2 HDMI input
3 DVI-I input
4 Card picture
5 Copy guarded signal
6 V-chip blocked program
7 i.LINK input
8 DTV Program

Rec. Mode

Use this setting for recording images you are currently
watching. You can select the recording mode (picture
quality) for a motion picture.

Press a/b to select “Rec. Mode”, and then
press ENTER.

Press MENU and the MENU screen displays.

Press c/d to select “Card Setup”.

Press a/b to select “Video Setup” and then
press ENTER.

Rec. Mode

Pre Record

Repeat Play

File Operation

Press a/b to select the desired mode, and
then press ENTER.

Press CARD and the card mode screen
displays.