Sony Data Projector VPL-MX20 - Manual (Page 50)

50
Replacing the Lamp
Do not put your hands into the lamp
replacement slot, and do not allow any
liquid or other objects into the slot to avoid
electrical shock or fire.
5
Insert the new lamp all the way in until
it is securely in place (a). Tighten the
two screws (b). Fold down the handle
to replace it (c).
• Be careful not to touch the glass surface
of the lamp and a inside conductor.
• Insert the handle firmly to attach it
securely.
• The power will not turn on if the lamp is
not secured properly.
6
Close the lamp cover and tighten the
two screws.
Be sure to attach the lamp cover securely
as it was. If not, the projector cannot be
turned on.
7
Turn the projector back over.
8
Connect the power cord.
The ?/1 key lights in red.
9
Press the ?/1 key to turn the projector
on.
10
Press the MENU key, and then select
the Setup menu.
11
Select “Lamp Timer Reset”, and then
press the ENTER key.
“Settings for Lamp replacement. Has the
projection Lamp been replaced?” is
displayed in the menu screen.
12
Select “Yes” with the b key, and then
press the ENTER key.
The Lamp Timer is initialized to 0,
“Lamp Timer Reset Complete!” is
displayed in the menu screen.
13
Select “Yes” and press ENTER key.
To erase a message, press any key on the
control panel of the projector or on the Remote
Commander.
Caution
Notes
Note
Fold down
the handle.
Note
Disposal of the used lamp
For the customers in the USA
Lamp in this product contains mercury.
Disposal of these materials may be
regulated due to environmental
considerations. For disposal or recycling
information, please contact your local
authorities or the Electronic Industries
Alliance (www.eiae.org).
Settings for Lamp replacement.
Has the projection Lamp been replaced?
Yes No
Lamp Timer Reset