Turning off the power – Sony Data Projector VPL-MX20 User Manual
Page 28
28
Turning Off the Power
Turning Off the
Power
1
Press the ?/1 key.
“POWER OFF? Please press ?/1 key
again.” appears to confirm that you want
to turn off the power.
The message disappears if you press any
key other than the ?/1 key, or if you do not
press any key for five seconds.
2
Press the ?/1 key again.
The powered tilt adjuster is retracted
into the projector. The ?/1 key flashes in
green and the fan continues to run to
reduce the internal heat.
3
Unplug the AC power cord from the
wall outlet after the fan stops running
and the
?
/1
key
lights in red. (Except
when using the Off & Go function)
When you cannot confirm the on-
screen message
When you cannot confirm the on-screen
message under certain conditions, you can
turn off the power by holding the ?/1 key for
about two seconds instead of above steps 1
and 2.
To project again immediately, you can make
the lamp light by turning on the power again
even, while the ?/1 key is flashing in green.
There may be a delay, depending on
conditions, before the lamp lights.
Note