Sony Data Projector VPL-MX20 - Manual (Page 25)

25
Projecting
Pr
oj
ec
tin
g
t
h
e
P
ict
ur
e
To connect to a video GBR/
Component output connector
• Set the aspect ratio using “Aspect” on the
Screen menu according to the input signal.
• When you connect the projector to a video
GBR output connector, select “Video GBR”
or when you connect the projector to a
component output connector, select
“Component” with the “Input-A Signal Sel.”
setting on the Setup menu.
Projecting
1
Plug the AC power cord into a wall
outlet, then connect all equipment.
The ?/1 key lights in red and the
projector goes into standby mode.
2
Press the ?/1 key.
The ?/1 key flashes in green and the
Advanced Intelligent Auto-setup starts.
The powered tilt adjuster rises and stops
at the previously adjusted position and
adjusts the focus.
Notes
Side
VCR
to video
GBR/
component
output
Signal Cable (not
supplied)
HD D-sub 15-pin
(male)
y 3 ×
phono plug
to INPUT A
connector
INPUT
MENU
NETWORK USB
RESET
AUTO FOCUS
D ZOOM
LENS
ENTER
VOLUME
KEYSTONE
/TILT
FREEZE
PIC MUTING
AUDIO MUTING
APA