Southbend EVS Tool Room lathe w/DRO SB1059F - Manual (Page 29)

For Machines Mfg. Since 3/11 EVS Toolroom Lathe w/DRO
-27-
P R E P A R A T I O N
Lifting & Moving
This machine and its parts are heavy! Serious
personal injury may occur if safe moving
methods are not used. To reduce the risk of a
lifting or dropping injury, ask others for help,
and use power equipment and guide rods.
Do not attempt to lift or move this lathe without
using the proper lifting equipment (such as
forklift or crane) or the necessary assistance from
other people. Each piece of lifting equipment
must be rated for at least 25% more than the
shipping weight of your lathe to support dynamic
loads that may be applied while lifting. Refer to
Things You'll Need on Page 21 for details.
To lift and move the lathe:
1. Remove the shipping crate top and sides,
then remove the small components from the
shipping pallet.
2. Move the lathe to its prepared location while
it is still attached to the shipping pallet.
3. Unbolt the lathe from the shipping pallet
4. To balance the load for lifting, move the
tailstock and carriage to the extreme right
end of the bedway, then lock them in place.
Note: Before attempting to move the carriage,
make sure the carriage lock is loose, the half
nut is disengaged, and the power feed is
disengaged (feed ON/OFF lever).
5. Position hardwood blocking under each
end of the bed as shown in Figure 14.
This will keep the lifting straps away from
the leadscrew, feed rod, and spindle rod to
prevent bending them during lifting.
Lifting
Strap
Lathe
Bed
Leadscrew
Feed Rod
Control
Rod
To Power Lifting Equipment
(Loooking at Lifting Setup from Tailstock End)
Hardwood Blocks
and Planks
Positioned as
Required to
Prevent Lifting
Straps from
Bending
Leadscrew
Figure 14. Lifting setup to keep straps from bending
leadscrew or rods.
6. Attach the lifting straps to the power lifting
equipment (see Figure 15 for an example).
Power Lifting
Equipment
Lifting
Straps
Use Blocks as Necessary
to Space Straps Away
from Control Rod,
Feed Rod, and Leadscrew
to Prevent Bending when
the Lathe is Lifted
Hardwood
Blocking
Hardwood
Blocking
Figure 15. Example of lathe setup for lifting.