SIIG 04-0373C - Manual (Page 8)

8
3. Select Rebuild Mirror set then press Enter.
4. Select Offline rebuild then press Enter.
5. When asked Are You Sure (Y/N)?, press Y to confirm.
6. The mirror will start to rebuild. When rebuilding
finishes, press Ctrl+E to exit. (Rebuilding can take
30-120 minutes depending on the size of the mirror).
7. When asked Are you sure to exit (Y/N)?, press Y to
exit and reboot.
Deleting RAID Arrays
1. As the BIOS boots press Ctrl+S or F4 when prompted
to enter the RAID BIOS.
2. Select Delete RAID Set, then press Enter.
3. Press Enter.
4. When asked Are You Sure (Y/N)?, press Y to confirm.
5. The RAID set is now deleted.
Resolving Conflicts
When a RAID set is created, the metadata written to the
disk includes drive connection information. If, after a
disk failure, the replacement disk was previously part of
a RAID set (or used in another system), it may have
conflicting metadata. If so, this will prohibit the RAID set
from being either created or rebuilt, in order for the RAID
set to function properly, this old metadata must be first
overwritten with the new metadata. To resolve this, from
the main BIOS window select Resolve Conflicts, then
press Enter, the correct metadata, including the correct
drive connection information, will be written to the
replacement disk.