SIIG 04-0373C - Manual (Page 11)

11
For An Existing Installation
1.
Install the board and boot up to Windows.
2. At the Add New Hardware Wizard, insert the driver
CD.
3. Select Automatic search for a better driver
(Recommended), then click Next.
4. Accept the default entry then click OK.
5. Click Finish.
6. Remove the driver CD, shutdown Windows, and
setup your RAID array.
When Windows resumes, go to SATARaid GUI on page
17 and install the RAID monitoring utility.
To Verify Windows 98SE/ME Installation
1. Right click My Computer and click Properties.
Select Device Manager tab.
2. Double click SCSI controllers, Silicon Image Sil
3512 SATARaid Controller should be displayed.
Windows 2000
A new installation of Windows 2000 requires a floppy
disk for the driver installation. To make this floppy disk,
copy the contents of the Floppy folder, found on the
driver CD, onto a blank floppy disk then follow the
directions below.
For A New Installation
1.
Setup the RAID array prior to Windows installation.
2. Follow Microsoft Windows 2000 installation
procedure.
3. Restart the computer when prompted by the
installation.