Sharp DT-200 - Manual (Page 47)

E-46
Maintenance & Tr
oubleshooting
Replacing the Lamp
• Be sure to remove the lamp cage by the handle. Do not touch the glass surface of the lamp cage or the inside of the
projector.
• To avoid injury to yourself and damage to the lamp, carefully follow the steps below.
• Replace the lamp after turning off the power and unplugging the power cord.
Removing and installing the lamp unit
CAUTION
Turn off the power. Unplug the power cord.
4 6
Loosen the user service
screw that secures the
lamp cage cover.
5
Slide the lamp cage
cover in the direction
of the arrow.
1 3 Turn off the power. 2 Unplug the power cord. Remove the Swivel
Stand. (See page 17.)
Loosen and remove the
three-securing screws
from the lamp cage.
Press POWER OFF. Wait until the
cooling fan stops running.
7 Remove the lamp cage.
User service screws
Insert the new lamp cage
firmly into the lamp cage
compartment. 8 9 Tighten the three-
securing screws to
fasten the lamp cage.
DT-2 00
DT-200(E)#p46_47.p65 02.11.21, 11:46 AM 46