Sharp DT-200 - Manual (Page 28)

E-27
Basic Operation
Language ( ) English
Deutsch
Español
Nederlands
Français
Italiano
Svenska
Português
Front
Front םCeiling
Rear
Rear םCeiling
Picture ( )
Tint ם30 מ30
Color ם30 מ30
Sharp ם30 מ30
Contrast ם30 מ30
Bright ם30 מ30
Red ם30 מ30
Blue ם30 מ30
Reset
5500k
6500k
8500k
9300k
10500k
Standard
Black Detail
White Detail
Memory 2
Memory 3
Memory 4
Memory 5
Memory OFF
Brighten
7500k
CLR Temp
Gamma
White Emphasis [ON/OFF]
Picture Setting Memory 1
Fine Sync ( )
Auto Sync [ON/OFF]
Clock ם30 מ30
ם30 מ30
ם30 מ30
Phase ם15 מ15
H-Pos
V-Pos
Reset
Special Modes
Signal Info
Resolution
Hor Freq
Vert Freq 640 ן480
37.5 kHz
72 Hz
Digital Shift ם30 מ30
Reset
RGB
Background
Options ( )
Component
Blue
None
Auto Power Off [ON/OFF]
Menu Position
Menu Color Opaque
Translucent
Center
Lamp Timer
OSD Display [ON/OFF]
Signal Type
Upper Right
Lower Right
Upper Left
Lower Left
Subtitle ם10 מ10
*
PRJ Mode ( )
640 ן480
720 ן480
Items on the INPUT 1 or 2 Mode Menu Bar
* The “Digital Shift” and “Subtitle” cannot be adjusted when
Keystone correction is applied.
• The resolution, vertical frequency and horizontal
frequency figures displayed above are for example
purposes only.
• “Color”, “Tint”, and “Sharp” do not appear when “RGB” is
selected in INPUT 2 mode.
• Only the items highlighted in the tree charts above can
be adjusted.
• To adjust the items under the sub menu, press after
selecting the sub menu.
• “Signal Type” is not displayed when using INPUT 1.
• “Contrast”, “Bright”, “Color”, “Tint” and “Sharp”, “Clock”,
“Phase”, “H-Pos” and “V-Pos”, and “CLR-Temp”,
“Gamma”, “Special Modes” and “Auto Sync” cannot be
used in the DIGITAL INPUT mode.
• “Clock”, “Phase”, “H-Pos” and “V-Pos” cannot be used in
the Component mode.
Main menu Sub menu Main menu Sub menu
Menu Bars
DT-200(E)#p26_32.p65 02.11.21, 11:38 AM 27