Care, Contact with liquid, Operation with a pabx – Siemens Gigaset CL100 User Manual
Page 23: Changing the dialling procedure, Setting the flash time, Changing pause after line seizure, Changing pause after recall key (dialling pause), Care contact with liquid operation with a pabx
23
Appendix
Gigaset CL100 / HGK eng / A31008-A221-H100-1-7619 / appendix.fm / 20.11.2003
Care
Wipe the base station and handset with a damp cloth or with an antistatic wipe. Never
use a dry cloth. This can cause static.
Contact with liquid
If the handset should come into contact with liquid, on no account switch the device
on. Remove all batteries immediately.
Allow the liquid to drain out of the device, and then pat all parts of the device dry.
Keep the handset with the batteries removed in a warm, dry place for at least 72 hours.
In many cases, you will then be able to use it again.
Operation with a PABX
The following settings are only necessary if your PABX requires them, please refer to
the operating instructions for your PABX.
Changing the dialling procedure
You can set the dialling mode to tone dialling (DTMF) or pulse dialling (IWV).
MENU
¢
BASE SET
¢
ADD FEATURES
¢
DIAL MODE
¢
Select dialling mode
¢
OK
Press
a
and hold (return to idle status).
Temporary switch to tone dialling (DTMF):
If your PABX works with pulse dialling but you need tone dialling for a call (e.g. to listen
to an external mail box), you must switch to pulse dialling during the call.
MENU
¢
TEMP TONE
Setting the flash time
MENU
¢
BASE SET
¢
ADD FEATURES
¢
TBR
¢
Select flash time (80 ms, 100 ms,
120 ms, 180 ms, 250 ms, 300 ms or 600 ms)
¢
OK
Press
a
and hold (return to idle status).
Changing pause after line seizure
Setting the length of the pause between pressing the talk key
c
and sending the
phone number (1 = 1 sec.; 2 = 3 secs.; 3 = 7 secs.; 4 = 2.5 secs., factory setting: 3 secs.).
MENU
¢
N
O
1
L
¢
Display symbol: 916 SET, the number for the current
pause length flashes
¢
enter a new number
¢
OK
Changing pause after recall key (dialling pause)
Setting the length of the dialling pause (1 = 800 ms; 2 = 1600 ms; 3 = 3200 ms, see
operating instructions for the PABX).
MENU
¢
N
O
1
2
¢
Display symbol: 912 SET, the number for the current
pause length flashes
¢
enter a new number
¢
OK
!
i
To insert a dialling pause press the
S
key for 2 seconds after you have
entered the prefix. A "P" appears in the display. Then enter the phone
number.