Sprint Nextel SP-809 - Manual (Page 23)

23
Telephone Operation
Follow these steps to store a number in memory.
1 Press PROG/MEM when
the handset is not in use.
2 Enter the number you want to store. (To store the last number
you dialed, simply press REDIAL .)
If you enter a wrong digit, repeat Step 1.
3 Press PROG/MEM then any number button ( 0-9 ) for the memo-
ry location. The SP-805 beeps three times.
Note: If you receive a call while you are storing information in
memory, press
PHONE to answer the call. A tone sounds in the re-
ceiver while the phone goes off-hook. After the call, begin again at
Step 1.
To replace a stored number, simply store a new one in its place.
Entering a Pause
In some telephone systems, you must dial an access code (9, for
example) and wait for a second dial tone before you can dial an
outside number. You can store the access code with the phone
number. However, you should also store a pause after the access
code to allow the outside line time to connect. To do so, hold down
the number immediately preceding the pause until you hear a sec-
ond beep. (For example, if 9 is your access code, hold down 9 until
you hear a second beep.) This enters a 1.5-second pause. For a
longer pause, hold down the number key until you hear additional
beeps.
43-5805.fm Page 23 Wednesday, August 18, 1999 1:22 PM