Sprint Nextel SP-809 - Manual (Page 14)

14
Preparation
Follow these steps to set the day and time so the TAD can record
the correct information when each message and memo is re-
ceived.
Note: If you do not complete each step within 20 seconds, the TAD
sounds two beeps and exits setup. Start again at Step 1.
1 Press CHANGE then
CLOCK . A number from 1 – 7
(the day of the week, with 1
being Sunday) appears on
the message counter window
and the TAD announces the
currently set day.
Note: The TAD’s message counter window might also alternately
show other information to tell you the status of the TAD.
2 Press REPEAT/SCAN
or SKIP/SCAN as instruct-
ed by the voice prompts.
3 When you complete setting the day and time, the TAD an-
nounces the day and time then beeps twice.
To check the current day/time at any time, press CLOCK .
ANNOUNCEMENT OPTIONS
You can record an announcement (up to three minutes long) that
callers hear when the system answers a call. If you do not record a
personalized outgoing message, the TAD plays
Hello. Please
leave a message after the tone.
CHANGE
CLOCK
REPEAT/
SCAN
SKIP/
SCAN
43-5805.fm Page 14 Wednesday, August 18, 1999 1:22 PM