Sony KL-W9000 - Manual (Page 9)

– 9 –
12 -EN Operations
1
If the STANDBY indicator on the front of the
monitor is lit in orange, press POWER on the
remote control to turn on the power.
Press the power switch (green) on the monitor if the
STANDBY indicator is not lit.
The green u (power) indicator flashes, then lights
up.
2
Turn on the power of the connected
equipment.
3
Press RGB or VIDEO to select the input you
want to watch.
The selected input indication is displayed on the
screen.
To watch a computer picture input from the
RGB IN connector
Each time you press RGB, the display changes as
follows:
RGB 1 ˜ RGB 2
To watch a video picture input from the
VIDEO IN jacks
Each time your press VIDEO, the display changes
as follows:
VIDEO 1 n VIDEO 2 n VIDEO 3
You can also select the input by pressing INPUT
SELECT on the monitor.
Each time you press INPUT SELECT, the display
changes as follows:
RGB 1 n RGB 2 n VIDEO 1 n VIDEO 2 n VIDEO 3
The input signal indication will automatically
disappear.
4
Press VOL +/– (VOLUME +/–) to adjust the
volume.
Remote control Monitor
Projecting the
picture
Operations
CENTER/
SIZE
VOL
ENTER
MENU
VIDEO
MUTING DISPLAY
POWER
RGB WIDE
POWER
RGB
INPUT SELECT
VIDEO
N
N
VOL VOLUME
+
–
MENU
VOLUME
LAMP
INPUT SELECT
STANDBY
ENTER
Power switch
(green)
13 -EN Operations
EN
Watching the video picture in wide
mode
You can enjoy a variety of wide mode picture.
Press WIDE until the mode you want appears
on the screen.
Each time you press WIDE, the mode changes as
follows:
NORMAL n FULL n ZOOM n SUB TITLE n WIDE ZOOM
To turn off the monitor
Press POWER on the remote control. The monitor
enters standby mode and the STANDBY indicator
lights up. To turn off the main power, press the power
switch (green) on the monitor.
Note
To protect the lamp mounted as a source of light, if you try to
turn on the power within about 30 minutes after the power has
been turned off, the u (power) indicator flashes and the picture
does not appear.
Muting the sound
Press MUTING.
“MUTING” appears on the screen.
To restore the sound, press MUTING again, or press
VOL+.
Displaying on-screen information
Press DISPLAY to display the following information on
the screen.
To make the on-screen information disappear, press
DISPLAY again.
Current input
signal
Picture mode
(page 14)
Current input
signal frequency
when the RGB
signal* is input
Watching the
picture in wide
picture mode
N
WIDE
CENTER/ SIZE MENU
VIDEO
MUTING DISPLAY POWER
RGB WIDE
(continued)
*fH: Horizontal frequency
fV: Vertical frequency
“OUT OF SCAN RANGE” appears if the scanning
frequency range is not within the acceptable
limits. (See page 9.)
NORMAL
RGB 1
fv:75
fh:37.5