SoundCraft UREI 1601E - Manual (Page 19)

19
FRONT PANEL
1. CH1: 3 Position curve control and Reverse
These controls allow you to change the curve of the input fader and reverse the fader action. See also page 23.
2. X-FADER: Rotary position curve control and Reverse
These controls allow you to change the curve of the x-fader and reverse the fader action. See also page 27.
3. CH2: 3 Position curve control and Reverse
These controls allow you to change the curve of the input fader and reverse the fader action. See also page 23.
4. LEVEL -Rotary control
This control sets the audio level to the connected headphones. See also page 28.
5. HEADPHONE OUT -Jack connectors
Connect the 1/4” or mini jack plug from your headphones to the appropriate connector.
6. SELECT Toggle switch
This switch allows you to select MASTER or CUE monitoring. See also page 28.
7. EQ CUT -Rotary
This control can be used to change the CUE monitor EQ. To the right, high frequencies are cut and to the left, low frequencies are
cut. See also page 28.