Directory, Steps for entering names and special characters – Sanyo CLT-5810 User Manual

Page 23

Text mode
Original mode

E21

DIRECTORY

Refer to the letters on the number keys to select the
desired characters.

With each press of a numeric key, the displayed character appears in
the following order: Upper case letters first, lower case letters next
and finally the number corresponding to the key.

If you make a mistake while entering a name

Use the

/TONE/

or #/

key to move the cursor to the

incorrect character.

Press the DELETE/CH key to erase it, then enter the correct character.
To delete all characters, press and hold the DELETE/CH key.

Steps for entering names and special characters

If the next character uses the same number key, you must press the #/

key

to move the cursor over. Otherwise the next time you press the number key,
it changes the character that was previously set.

Note:

UP015DH(CLT5810) ENG OM 3/9/05 10:37 AM Page 21