Sanyo CLT-5810 - Manual (Page 14)

Entering your area code
If you enter a 3-digit area code number in the Area Code option, your
local area code does not appear in Caller ID messages. Do not
program this option if your calling area requires 10-digit dialing.
When reviewing Caller ID messages, you will see only the local
seven digit number. For calls received from outside your local area
code, you will see a full 10-digit number.
1
When the phone is in standby mode,
press and hold the CID/MENU key.
The following screen appears.
2
Press the VOL/RING key twice to select
¨ Area Code ¨.
3
Press the SELECT key.
4
Use the number (0 - 9) or DELETE/CH key
to enter the 3-digit area code.
5
Press the SELECT key. A confirmation tone sounds and the
displayed area code is entered.
6
Press the END key or return the handset to the base unit to
complete the setting. The handset returns to standby mode.
E12
GETTING
STARTED
When the area code has already been stored in
memory, the stored area code will be displayed.
To change it, use the DELETE/CH key and
number keys to enter the new area code.
Then press the SELECT key. A confirmation tone sounds. To complete the
setting, press the END key or return the handset to the base unit.
Note:
UP015DH(CLT5810) ENG OM 3/9/05 10:36 AM Page 12